2. WIRING
2-7
8. Slide the rubber stopper into the hole of the boot cover, use two cable ties to fas-
ten the stopper to the boot cover.
9. For TZT9, fasten two binding screws to re-attach the fan cover.
Video input
TZT9/14 can use regular analog video inputs (PAL or NTSC) that connect to the TZT9/
14 directly or use IP cameras that connect directly to the network HUB. IP cameras
can be seen by all TZT9/14 connected to the NavNet TZtouch network, unlike analog
video that can be viewed only on the equipment where the source is connected. Ad-
ditionally some IP cameras can be controlled from TZT9/14.
Analog video
The TZT9/14 units have two analog video inputs (PAL/NTSC) on 2 mm RCA (cinch)
type connectors located on the rear of the equipment. For this connection, the follow-
ing cable is necessary (local supply).
• 3C2V (Japan Industrial Standard (JIS), or the equivalent) coaxial cable (impedance:
75Ω)
IP camera
IP cameras are network devices that connect directly to a HUB. Up to four IP cameras
can be connected to one NavNet TZtouch network. At this time, only AXIS IP cameras
that support MPEG4 video are functional in the network. For more details, see the op-
erator’s manual for AXIS models.
Boot cover
Push
Wind two cable ties around here.
Rubber stopper
Insulator
Shield
Vinyl sheath
Conductor
S = 0.19 mm
2
φ = 0.5 mm
To Next Page
Loading...
