Furuno TZT14 - How to Measure the Bearing with the EBL; How to Select the EBL Reference

6. RADAR
6-9
6.7.6 How to measure the bearing with the EBL
The EBL is a straight dashed line from the center of the screen to the edge.
1. Select [EBL] from the RotoKey menu.
2. Select [Adjust].
3. Drag the circle icon to put the EBL on the center of the target. Read the bearing
to the target at the left side of the circle icon.
4. Select [End EBL] at the top right-hand corner of the screen to erase the slider bar.
To delete the EBL, select [EBL] - [Clear] from the RotoKey menu.
You can operate the EBL from a pop-up menu.
6.7.7 How to select the EBL reference
You can select the EBL reference from [True] or [Relative]. [True] means the bearing
is in reference to the north. [Relative] means the bearing is relative to the heading of
your ship. True bearing requires a heading sensor.
1. Select [Menu] on the menu icon bar to open the main menu.
2. Select the [Radar] - [EBL Reference] menu.
3. Select [True] or [Relative].
4. Select [Close] to exit the menu.
End EBL
RADAR
RADAR
DATA 2
DATA
2
DA
DA
DATA 1
DATA 1
DATA 2
DATA 2
RADAR
RADAR
0
0
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
160
170
180
190
200
210
220
230
240
250
260
270
280
290
300
310
320
330
340
350
ATA 1
ATA
1
295.2 º
EBL
Target
Circle icon
Bearing to
the target
Relative
True
EBL Reference
Relative