Furuno TZT14 - Power on and off

1. SYSTEM INTRODUCTION
1-7
Tips and Notice for the Remote Control Unit
• In the cursor mode of the MCU-002, the cross cursor is easier to use than the arrow
cursor. To use the cross cursor, set [Cross Cursor] to [ON] in the [General] menu.
• You can not the guard zone with the MCU-002. Use the touch operation to set the
guard zone. For the guard zone, see section 6.12.
1.3 Power ON and OFF
Press the key to turn the power ON.
When you turn on the power, a beep
sounds and the start-up screen appears.
Approximately 90 seconds after you ap-
ply the power, the chart plotter display
appears.
To turn the power OFF, press the key. The following window appears.
Select [Power Off This Device] or [Power Off Network]. 15 seconds after the screen
goes blank, the power turns off. (The power is on for this 15 seconds.)
Note 1: Do not turn off the power during the start-up. Wait until the start-up is complet-
ed before you turn the power off.
Note 2: The screen refreshes slower in low ambient temperature.
NavData
Transparency
D
p
p
ep
t
h
Al
a
rm
V
a
l
e
ue
30.0
30.0
30
.
0
f
t
f
f
Synchronize Time with GPS
Synchronize Tim
mm
N
N
N
N
N
Nav
Nav
Nav
Nav
Nav
Dt
Dt
Dt
Dt
Dt
Dat
Dat
Dat
Dat
Dat
T
T
T
T
T
aT
aT
aT
aT
aT
ran
ran
ran
ran
ran
spa
spa
spa
spa
spa
ren
ren
ren
ren
ren
cy
cy
cy
cy
cy
Syn
Syn
chr
chr
oni
oni
ze
ze
Tim
Tim
Syn
Syn
y
y
y
y
y
chr
chr
oni
oni
ze
ze
m
m
m
m
m
m
Tim
Tim
ew
ew
ew
ew
ew
ew
e w
e w
ith
ith
ith
ith
ith
ith
ith
ith
GP
GP
GP
GP
GP
GP
GP
GP
S
S
S
S
S
S
S
S
Syn
Syn
Syn
Syn
Syn
Syn
Syn
Syn
chr
chr
chr
chr
chr
chr
chr
chr
oni
oni
oni
oni
oni
oni
oni
oni
ze
ze
ze
ze
ze
ze
ze
ze
T
T
T
T
T
T
Tim
Tim
m
m
m
m
m
m
m
m
m
m
m
m
m
m
C
ross
C
ur
sor
Set [Cross Cursor] to [ON].
Cross cursor
TZTBB:
Press here.
TZT9/TZT14:
Press here.
Power Off
This Device
Close
Power Off
Network
Brilliance
Select either one
of the two.