Furuno TZT14 - SST Alarm; Speed Alarm

2. CHART PLOTTER
2-12
2.10.3 SST alarm
The sea surface temperature alarms tells you when the sea surface temperature is
over, under, within, or out of range of the temperature you set. Requires a temperature
sensor.
1. Select [Sea Surface Temperature Alarm] from the [Alarm] menu.
2. Select [Over], [Under], [Within] or [Out of]. For [Over] or [Under], go to the next
step. For [Within] or [Out of], go to step 5.
3. Select [Temperature Alarm Value] to display the software keyboard.
4. Set the value for [Over] or [Under] then select [Confirm]. Go to step 9.
5. Select [Temperature Alarm Range Minimum Value] to display the software key-
board.
6. Set the minimum value for [Within] or [Out of] then select [Confirm].
7. Select [Temperature Alarm Range Maximum Value] to display the software key-
board.
8. Set the maximum value for [Within] or [Out of] then select [Confirm].
9. Select [Close].
2.10.4 Speed alarm
The speed alarm tells you when the speed of your ship is over or under the limit set.
Set the value at [Speed Alarm Value]. Requires a GPS navigator or speed sensor.
1. Select [Speed Alarm] from the [Alarm] menu.
2. Select [Under] or [Over].
Off
Over
Under
Within
Out of
Sea Surface Temperature Alarm
Off
Off
Under
Over
Speed Alarm
Off