Furuno TZT14 - How to Put an Event Mark; How to Display the Point Information

4. POINTS
4-2
4.2.2 How to put an event mark
This function is available by touch control when you select [Event] in [General] - [Func-
tion Gesture] of the main menu (see section 1.15).
1. Tap the screen with two fingers.
You can open the above window from the [Event] RotoKey menu.
2. Select a desired mark.
The following occurs.
• The selected mark is put at the position, at the time the RotoKey
TM
was pushed or
the screen was tapped to open the [Creating Event] window.
• The event mark is saved to the points list.
Most of the operations are common in points and event marks.
4.3 How to Display the Point Information
Select a point to display the information (name, depth, com-
ment, bearing and range) about a point.
For an event mark, the comment is automatically entered ac-
cording to the setting in the [Points] menu.
1. Select [Menu] on the menu icon bar to open the main
menu.
2. Select the [Points] - [Data to Be Recorded in Event Comment] menu.
3. Select an option.
[None]: No comment
[Date]: Date
Cancel
Creating Event
Name
Depth
Comment
POINT1
443 ft
Bearing
Range
17.9 °M
0.822NM
None
Date
SST
Date And SST
Data to Be Recorded in Event Comment
None