2. WIRING
2-2
2.2 Composite Connector
The composite connector, at the rear of the unit (See the figure on page 2-1), contains
connection leads for Video In (two leads), LAN (two leads), HDMI (two leads for
input and output), NMEA2000, MULTI, USB ports (two leads for Type A and microB)
and DI-FFAMP.
Analog video input
The TZT16F can use regular analog video inputs (PAL or NTSC) that
connect to the TZT16F directly via the Video Input 1/2 connectors. Analog video can
be viewed only on the equipment where the source is connected.
Additionally FLIR cameras may be connected to the TZT16F. Connect the Video Out
cable from the camera to the Video In (1 or 2) cable on the TZT16F.
Note: Some camera models may require an adapter for connection.
Cameras may be set up using the appropriate menu item on the [Camera] menu,
accessed from the [Settings] menu. For details on camera setup, see the operator’s
manual (OME-45120-x)
Nerwork1/2
You can connect to an external network device using a LAN cable. Use HUB-101 (op-
tion) when connecting multiple devices. The MCU-005 can be also used by using a
PoE hub.
Video out (external HDMI monitor)
A HDMI monitor can be connected to the TZT16F to repeat the screen at a remote
location. The TZT16F is compatible with wide-screen HDMI monitors which meet the
following minimum requirements:
Video in (HDMI Source Devices)
Video data from HDMI source devices can be watched on TZT16F by connecting the
device.
CAN bus port
TZT16F can be connected to multiple NavNet TZtouch3 using the CAN bus connector
(micro type). In that case, connect them all to the same CAN bus backbone cable (Re-
fer to section 2.8 for details).
MULTI port
You can connect to external devices such as buzzers and event switches. Refer to
section 2.5 for details.
USB port
The TZT16F has two USB Ver. 2.0 ports which can be used to connect an optional SD
card unit or remote control unit, and to control a touch monitor.
Resolution Vert. Frequency Horiz. Frequency Pixel clock
1920 1080 60 Hz 67.5 kHz 148.5 MHz
To Next Page
Loading...
