Furuno TZT16F - Page 37

2. WIRING
2-11
Mid/Large-size vessels (External GPS, Fish Finder, Radar)
This is a single station plotter/radar/fish finder installation.
Refer to "SYSTEM CONFIGURATION" on page ii for more details.
GPS RECEIVER
GP-330B
*
3
Radar Sensor
DRS6A X-Class, DRS12A X-Class,
DRS25A X-Class
DRS6A-NXT, DRS12A-NXT, DRS25A-NXT
Radar Sensor
DRS4DL+/DRS4D-NXT
12 to 24 VDC
12 to 24 VDC
12 to
24 VDC
12 to 24
VDC
Two-way cable
(MOD-ASW0001/ASW002)
*
1
: The HUB-101 is required when two or
more pieces of network equipment are
connected to the TZT3 unit.
*
2
: Local Supply
*
3
: Backup
Transducer
B/CM265LH, B/CM275LHW
HUB-101*
1
OR
Multi Function Display
TZT16F
Multi Function Display
TZT16F
Multi Function Display
TZT16F
Multi Function Display
TZT16F
CAN bus backbone cable
CAN bus
drop cable
CAN bus
drop cable
USB Hub*
2
Remote Control
Unit
MCU-002
SD Card Unit
SDU-001
Optional LAN cable
MOD-Z072/Z073,
2 m, 3 m, 5 m, 10 m
Cable Assy.
FRU-2P5S-FF
Transducer
520-PLD/5PSD/5MSD/5PWD
Conversion
cable
CAN bus
drop cable
12
*4
to 24 VDC
*
4
: 12 VDC is only used with DRS6A-NXT.
All other open array DRS sensors require 24 VDC.