3. HOW TO SET UP THE EQUIPMENT
3-20
12. Tap [X] on the title bar to close the menu.
3.7 Ferry Mode
Note: Only the SC-30, SC-33, and SCX-20 support the Ferry Mode.
Ferry mode allows the user to change the screen orientation by 180°. Note that all the
above heading sensors must support heading offset command from the TZT16F. Both
heading sensors and radar sensors must be powered on when the TZT16F sends the
command. Both the heading sensor and radar sensor must be powered when the
TZT16F sends the heading offset command to them. If TZT16F sends the command
and one of the sensors does not receive it, the heading data may be reversed. See
"[Event Input Configuration]" of "[Initial Setup] menu (Other menu items)" on page 3-8.
To Next Page
Loading...
