Furuno UAIS TRANPONDER FA-150 - 1.7 Selecting a Display

1. OPERATION
1-12
1.7 Selecting a Display
Use the DISP key to select a display. Each time the key is pressed, the display
changes in the sequence shown below.
TARGET LIST
DANGEROUS
LIST
OWN STATIC
DATA 1
OWN STATIC
DATA 2
OWN STATIC
DATA 3
OWN STATIC
DATA 4
OWN STATIC
DATA 5
OWN DYNAMIC
DATA
ALARM
STATUS
PLOTTER
DISPLAY
OWN SHIP'S STATIC DATA
Switch among these
displays with
.
(See section 1.7.4.)
ALARM STATUS DISPLAY
(See section 3.5.)
OWN SHIP'S DYNAMIC DATA
(See section 1.7.5.)
DANGEROUS (TARGET) LIST
(See section 1.7.3.)
When a dangerous target
exists, the dangerous target
list has priority.
TARGET LIST
(See section 1.7.2. )
PLOTTER DISPLAY
(See section 1.7.1.)
Switch between these
displays with
, .