23
6 Initialization of index file
After changing software configuration, initialize the index file on the memory device.
This procedure is also called “Index Clear” or “Clear Index.”
IMPORTANT!
Initialize index file after software configuration.
Index clear is made through Configuration menu as below.
1. Go to Configuration menu.
2. Select “0; All device” in the pull-down menu.
3. Press Clear index button.
4. After clear index finished, reboot VR-3000/S . (Power Off-On) Don’t use the
Reboot VR-3000 button when normal operation. The Reboot VR-3000 button is
only used for software debug.
Fig. 6.1
Configuration menu
When the index file is initialized successfully, the record number in the status monitor
will be reset to zero
.
To Next Page
Loading...
