Furuno VR-7000 - Brilliance Sharing Function

1. OPERATION
1-16
1.3.8 Brilliance sharing function
The RAP can share the brilliance settings with EC-3000/3005 units (ex: ECDIS, chart
radar) in the same network. When you adjust the brilliance of the EC-3000/3005 units,
the brilliance of the RAP is automatically changed. Note that the brilliance of the EC-
3000/3005 units is not changed according to the RAP brilliance change.
To turn the brilliance sharing function on or off, do as follows.
Note: The VDR software version must be “01.40” or after to use the brilliance sharing
function. Also, it is required to enable the function from the service menu. For details,
contact your dealer.
1. Press the MENU/ESC key to open the main menu.
2. Use the cursorpad ( or ) to select [Settings] then press the ENT key.
3. Use the cursorpad ( or ) to select [Brilliance Sync] then press the ENT key.
4. Use the cursorpad ( or ) to select [ON] or [OFF] then press the ENT key.
To turn the brilliance setting function, select [ON].
5. Use the cursorpad ( or ) to select [Brilliance Sync Settings] then press the
ENT key.
6. Adjust the preset brilliance of the LCD and keys for the day, dusk and night.
Key Beep
Brilliance Sync
Brilliance Sync Settings
Serviceman Settings
Shown when the brilliance sharing
function is enabled at installation.
To enable the function, contact
your dealer.
Brilliance Sync
ON
OFF
Brilliance Sync Settings
LCD
Day
Key
55
Dusk
Night
4
3
4
3
BRILL
LCD Min
Min
Max
MaxKe
y
5
5
◄
►
▼
▲
Select [Day], [Dusk]
or [Night], then
press the
ENT
key.