2. WIRING
2-17
2.6 Waterproof Microphone VR-7012W
Connect wiring to the terminal board of the unit, referring to the interconnection dia-
gram at the back of this manual. See section 1.6 for how to fabricate the cable.
After wiring the cable, reattach the front panel to the waterproof cover. Then fasten the
super gland or SC lock to fix the cable.
Front panel of the waterproof microphone (rear side)
After fabricating the cable, connect it to the connector J1.
Pin No. Signal In/Out
1
2
3
4
12 VDC
GND
MIC_AUDIO
MICTEST
In
-
Out
In
Connector J1
Fasten the cable gland or cable lock.
To Next Page
Loading...
