2. WIRING
2-37
2.9 Intelligent HUB HUB-3000
Fix the LAN cable connected to the cable clamp using the cable ties (supplied).
2.10 Power Supply Unit PSU-011
For wiring details, refer to the interconnection diagram at the back of this manual.
1. Unfasten the cable clamp.
2. Remove four screws to remove the cover from the unit.
3. Attach the crimp-on lugs (FV2-4, supplied) to the power cable, then connect be-
tween the PSU-011 and J1 port on the DCU.
4. Attach the crimp-on lugs (FV2-4, supplied) to the power cable, then connect be-
tween the PSU-011 and power source.
5. Fasten the cable clamp, then reattach the cover.
No use.
Power port
Power Fail
LAN port
Ground wire
(IV-1.25sq., supplied)
DPYC-1.5 cable
DPYC-1.5 cable
to network equipment
Attach the LAN port cap (supplied) to the unused connector
holes to provide waterproofing standard IPX2.
LAN cable
Cable clamp
To Next Page
Loading...
