1. INSTALLATION
1-4
1.2.4 Windows
®
XP
Deactivate the firewall
1. Click [Start], [Settings], [Control Panel] and open [Network Connections].
2. In the [Network Connections] window, right click [Local Area Connection] and se-
lect [Properties].
3. In the [Local Area Connection Properties] window, click the [Advanced] tab.
4. Uncheck the [Protect my computer and network by limiting or preventing access
to this computer] from the [Internet] option.
If you try to use the Maintenance Viewer with the firewall active, VDR settings cannot
be downloaded or updated.
To reactivate the firewall, check [Protect my computer and network by limiting or pre-
venting access to this computer] at step 4 in the procedure.
Install the software
1. Insert the program CD into the CD drive.
2. Run view.exe on the program CD to show the Setup-VR-7000 dialog box.
3. Click the [Next] button.
4. Confirm that the install location is “C:\Program Files\FURUNO” then click the
[Next] button.
5. Click the [Yes] button.
6. Click the [Next] and [Install] buttons to install the software.
7. After the installation is completed, the message “Yes, restart computer now” is
checked. Click the [Finish] button to complete the installation and restart the PC.
Grant administrator access
Full administrator access is necessary to install and run the Maintenance Viewer pro-
gram. Grant administrator access as follows:
1. Right click on the application's shortcut icon.
2. Select [Properties].
3. Click the [Compatibility] tab.
4. At [Privilege Level], check [Run this program as an administrator] then click the
[OK] button.
To Next Page
Loading...
