FUTABA 4PK-2.4G SuperR - ESC Link Function MCLNK

Communication port
(interior left side)
Cover
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
MC402CR
MC950CR
MC960CR
MC602C
MC851C
114
Function
(Opening Screen)
MENU 1
Press t
he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t
he button
* When the direct call button
is set, the setup screen is also
called by the following method:
-When the T4PKSR battery voltage drops, the display switches to low battery display.
Therefore, use this function when there is ample battery capacity remaining.
-Also connect the battery at the ESC side.
ESC Link Function "MCLNK"
This is a special function which allows Futaba motor controller (MC) data changes to be
set by the T4PKSR transmitter (MC960CR, MC950CR, MC851C, MC602C, MC402R,
etc.).
However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter. The T4PKSR power
switch is used at the display side. Use the various optional servo extension cords according to
the distance between the transmitter and ESC.
The last data read from ESC to T4PKSR or the last data written from T4PKSR to ESC is
saved to the T4PKSR. Since the data for each model memory can be saved, the data of up to
40 models can be saved.
ESC Link Function "MCLNK"