* When the direct call button
is set, the setup screen is also
called by the following method:
Adjuster "ADJST"
(Preparation)
In the steering side selected state, select the adjustment
screen by pressing the (JOG) button.
1
(Steering neutral adjustment)
In the neutral setup screen (figure at the right) state, lightly
pull the steering wheel and then press the (JOG) button in
the state in which the wheel is not being touched.
2
(Steering throw adjustment)
In the throw setup screen (figure at the right) state, lightly
turn the wheel fully to the left and right and press the (JOG)
button.
3
(Correction execution)
At the check screen, and press the (+) and (-) buttons simul-
taneously.
Steering adjustment
However, if correction was applied, it may be
necessary to recheck the set values of all the set-
up functions.
Adjuster "ADJST"
Steering and throttle correction can be applied. Use this function when a mechanical
offset has occurred for some reason.
•Select the setting item by
button
*
blinks at the current
setup item.
Throttle
Steering
To Next Page
Loading...
