* When the direct call button
is set, the setup screen is also
called by the following method:
•Select the setting item by
button
*
blinks at the current
setup item.
FWRD
Servo travel
BRAKE
0%
50%
100%
0%
50%
100%
Setup item
FWRD :
Forward side
acceleration amount
BRAK :
Brake side
acceleration amount
- Operation near the throt-
tle trigger neutral position
becomes a sharp rise.
- The forward and brake
sides can be set separate-
ly.
- When the brake mixing
function (p.74) is set, the
CH3/CH4 brake can also
be set.
Operation
Throttle Acceleration "ACCEL"
(Throttle system)
The servo will jump to the input position at its maximum possible speed. Unlike expo-
nential, which adjusts the whole throttle movement into a curve, throttle acceleration
simply "jumps" away from neutral and then leaves the remaining response linear.
Throttle Acceleration "ACCEL"
The standard value (100% point) of this setup affects the operation amount set by
throttle EPA function.
Set value
For gasoline engine cars, the linkage must have a
clearance because one servo controls the engine
carburetor and brake. Thus, there is a noticeable
time delay at both the forward and brake sides.
Sharp response comparable to that of electric mo-
tor cars is obtained by reducing this clearance at
the transmitter side.
Convenient usage method
Setting item
selection
- Select by (JOG) button up
or down operation.
To Next Page
Loading...
