Special Mixes "S-MIX" (4WS MIX)
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch func-
tion (p.96) is set.
1
(4WS type selection)
Operate the (JOG) button up and down and select the set-
ting item "MODE". Select the type by pressing the (+) or (-)
button.
"OFF" :Function OFF (front only)
"2TYP" :Front side only, reverse phase switching
"3TYP" :Front side only, reverse phase and same phase switching
"4TYP" :Front side only, reverse phase, same phase, and rear side only switching
4WS mixing adjustment
Switched in the order shown in the gure below by set SW
2
(Rear side travel adjustment)
Operate the (JOG) button up and down and select setting
item "RATE". Adjust the rear side travel with the (+) or (-) but-
ton.
3
(Mix mode setting)
Operate the (JOG) button up and down and select the setting
item "MXMD". Set the mix mode with the (+) or (-) button.
"OFF"
:
The EXP function of the 1st CH and other settings are not mixed.
"MIX" :The EXP function o the 1st CH and other settings are mixed.
4
To end setting, return to the opening screen by pressing the
(END) button three times (for direct selection, press the (END)
button once)
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, MIX
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
"2TYP"
：
Front side only and reverse phase switching
"3TYP"
：
Front side only, reverse phase, and same phase switching
"4TYP"
：
Front side only, reverse phase, same phase, and rear side only switching
The mixing amount can be adjusted by using the function dial function (p.98).
Dial / Trim Setting
To Next Page
Loading...
