13
placing large demands on the power systems in use today. When us-
ing a regulator you must ensure that the regulator is capable of sup-
plying the current demands of the equipment you have selected. In
addition to this make sure the wiring and switch you have selected are
capable of handling high current draws.
*The servo current draw can be up to 50% higher on a flybarless helicopter. Always en-
sure your receiver battery is fully charged before each flight.
ABOUT CONNECTOR:
Insert the connector such as sensor, servo, connection cord, battery
etc., surely.
*If it is not securely inserted all the way in, it may come off due to vibration during flight
and there is a danger of falling.
ABOUT WIRING:
Please secure the wiring so that it does not rub against the helicop-
ter frame or other such items that could cause wear. If it does so, we
suggest covering these ares with fuel tubing (or similar) to prevent
damage.
ABOUT VIBRATION ISOLATION AND WATERPREEFING:
The CGY760R is fixed with a dedicated mounting pad with good
condition and the helicopter performs sufficient anti-vibration mea-
sures so as not to receive strong vibration at the time of flight. Also, if
there is a risk of the gyro getting wet, place it in a plastic bag and take
waterproof measures.
ON FLIGHT PRECAUTION:
Always exit programming mode before attempting to fly the model.
Gyro operating precautions:
The CGY760R requires 5-10 seconds to initialize when the power is
turned on. Do not move the helicopter and do not move the tail rotor,
aileron and elevator sticks during this initialization or the gyro may not
initialize properly. Once the initialization process has been completed
the swash servos and tail servo will move several times indicating that
To Next Page
Loading...
Need help?
General
