42
From 2/3
Go to 1/3 from any
cursor position
Go to the menu title of
SBUS BASIC screen 1/3
SBUS BASIC screen 3/3
(11)
Via trainer channel
The transmitter’s trainer channel uses two consecutive chan-
nels. For example, if CH11 is set to "# 1", CH12 is automati-
cally set to "# 2". Therefore, when using this function, two
consecutive free channels are required for the transmitter. It
is not possible to use a channel assign that is used for an
-
other function. Move the cursor to "Via Trainer #" and press
the [Enter] keyto enter the setting mode. When "EXECUTE:
Enter (1sec)"is displayed. Use the [
/
+] or [
/
-] key to set
the channels. Press the [Enter] key for about 1 second to
to set the channelsfor the programming via trainer from the
transmitter.
(12) RESET: S.BUS data reset
This resets the S.BUS channel assignments back to the
defaults. Move the cursor to "RESET" by pressing the
[
/
+] or [
/
-] key, and
press the [Enter] key to enter the re-
set mode. When "EXECUTE: Enter (1sec)" is displayed,
press and hold the [Enter] key for about 1 second to
initialize S.BUS channel setting. If you do not wish to
reset to the default settings, press [Enter] key or [Esc/
Page] key to exit reset mode.
Transmitter Connection Cord
Trainer jack of the
transmitter.
CAUTION
Be sure to connect and disconnect the transmitter
and GPB-1 connection cord with the power off.
When changing "Via transmitter CH". Turn both
the CGY760R and the transmitter off after chang-
ing the channel assignment. Until the gyro is
power cycled, the wireless will not work.
To Next Page
Loading...
Need help?
General
