43
About Transfer Function Of Gyro Setting Data
:LWKWKLVIXQFWLRQE\FRQQHFWLQJWKHWUDQVPLWWHUDQGWKH*3%ZLWKWKHWUDQVPLW-
WHU FRQQHFWLRQ FRUG LW LV SRVVLEOH WR ZLUHOHVVO\ FKDQJH WKH VHWWLQJ RI WKH &*< 5
PRXQWHGRQWKHPRGHOYLDWKHWUDQVPLWWHU)RUWKHOLVWRIIXQFWLRQVWKDWFDQEHFKDQJHG
UHIHUWRSDJH%HIRUHFRQQHFWLQJWKH*3%WRWKHWUDQVPLWWHUSOHDVHFRQQHFWWRWKH
&*<5¿UVWDQGVDYHWKHRULJLQDOGDWDWRWKH*3%DFFRUGLQJO\
Setting on transmitter side
1. Follow the transmitter’s instruction manual, to set these items to the correct configu-
ration. Use the TX's Function menu to set two consecutive free AUX channels to
match the channel assignments set in the gyro SBUS menu. However, do not set
the "Control" and "Trim" functions.
2. Set the two free channels to the following settings.
Sub Trim: 0 / Fail safe: hold)/ Battery fail safe: OFF / Set the end point: 100
The limit point:155 (maximum) / Servo speed: 0 / Servo Reverse: Normal
3. Set the trainer function as follows according to the transmitter’s instruction manual.
Always ON
Teacher / Student: ----------------------------------------------------------------------Teacher
Channel mode: -----------------------------------------------------------------------------16CH
Mode for individual channels being used for gyro programming: ---------- Normal
Rate: -------------------------------------------------------------------------------------------- 100
Point : In 12ch FASSTest mode only the first 12 channels can be used for wireless trainer. In 18ch
FASSTest it is possible to use 18chs.
$IWHUFRQQHFWLQJWKH*3%WRWKHWUDQVPLWWHUYLDWUDLQHUSRUWSRZHURQWKH WUDQVPLWWHU
Upon turning the transmitter
"
2Q
"
WKH*3%ZLOOVKRZWKHRSHQLQJVFUHHQDQGWKH,'VFUHHQ
ZLOOEHGLVSOD\HG7KH,'QXPEHUVKRXOGEHWKHVDPHDVWKH,'VWLFNHURQWKH&*<5,I
WKH,'QXPEHUVPDWFKSUHVVDQGKROGWKH>(VF3DJH@NH\WRGLVSOD\WKHWUDLQHUYLDIXQFWLRQ
VHWWLQJVFUHHQNote:LIWKH,'LVGLIIHUHQWRQWKH,'FRQ¿UPDWLRQVFUHHQFRQQHFW&*<5
DQG*3%WRXSGDWHWKHFXUUHQWVHWGDWDRIWKH&*<5WR*3%
Opening screen ID screen
Via Trainer screenHome screen
Press and hold
the[Esc/Page] key
Press and hold
the[Esc/Page] key
Press and hold
the[Esc/Page] key
Press and hold
the[Eter] key
Press the [Enter] key
with the cursor on the
"Via Trainer"