57
RUD. BASIC screen 1/2
(1) Servo Type
Select the appropriate setting for the tail rotor servo. Move the cursor to
"Servo Type"
by pressing the [ /+] or [ /-] key
and press the [Enter] key
to enter the setting mode. Then select the servo types: DG1520, DG760
or Analog with the [
/+] or [ /-] key
.
When "EXECUTE: Enter (1sec)" is
displayed, press the [Enter] key for about 1 second to
changes the se-
lected type and exits the setting mode.
Setting: Analog / DG:1520 / DG760
Initial setting: DG:1520
DG 1520: BLS254, BLS257, S9254, S9257
DG 760: BLS276SV, BLS251SB, BLS251, S9256, S9251
WARNING
The servo type parameter within the CGY760R
must match the type of servo you are using. Incor
-
rect settings may damage the CGY760R or the
servo. An incorrect setting may also result in a loss
of control during flight.
From 2/2 From the "Work Mode." of
RUD. BASIC screen 2/2
Go to 2/2 from any
cursor position
(2) Gyro. Dir: Gyro direction
This parameter controls which direction the CGY760R (yaw axis) will
compensate when the helicopter rotates. Hold the tail rotor linkage over
the linkage ball on the servo, pick the helicopter up by the main shaft
and rotate the mechanics counter-clockwise. The CGY760R should
compensate by adding clockwise rotation pitch to the tail rotor blades. If
the CGY760R compensates by adding counter-clockwise rotation pitch
to the tail rotor blades, then it will be necessary to reverse the Compen-
sation Direction setting by pressing the
[
/+] or [ /-] key
.
Setting value: Normal / Reverse Initial value: Normal
3D
: :
:
To Next Page
Loading...
Need help?
General
