67
Governor Speed Setting
,IWKHJRYHUQRUVZLWFKLV21ZKHQWKHSRZHULVWXUQHG21WKHJRYHUQRUZLOOQRW
WXUQ21
2QFH\RXWXUQRIIWKH21VWDWHWKHJRYHUQRULVUHDG\IRURSHUDWLRQ$OZD\VWXUQ
RIIWKHJRYHUQRUZKHQVWDUWLQJWKHHQJLQH
7KH &*<5¶V USP VHOHFWLRQ LV DFFRPSOLVKHG E\ VHWWLQJ WKH FKDQQHO LQ VHFWLRQ
(8)
"
RPM channel
"
PHQXORFDWHGZLWKLQWKH
"
6%86%DVLF6HWWLQJ
"
to the governor
VSHHGVHWWLQJFKDQQHORI\RXUV\VWHPSDJH:KHQXVLQJDQLQGHSHQGHQWJRYHU-
QRURQRIIVZLWFKDFWLYDWHWKHVHFWLRQ
"
*RYHUQRURQRIIVZLWFK
"
IXQFWLRQZLWKLQ
the
"
Governor Basic Setting
"
VHFWLRQHDUOLHULQWKLVPDQXDOSDJH
Direct set by transmitter on Gov. mixing
• When governor mixing is used to switch the RPM of the rotor head speed, the head
speed can be switched with each condition of the switch.
*For a description of the governor mixing, please refer to your transmitter’s manual.
Using by 3 position switch
• Set the RPM at each switch position in the "(5) RPM setting" menu within the "Gover-
nor Basic Setting" section earlier in this manual (page 62).
Governor operation
7KH&*<5RSHUDWHVIURPWRUSPPDLQURWRUVSHHG+RZHYHUWKHHQ-
JLQHPXVWEHUXQQLQJDWWKHVHWVSHHG7KH&*<5WXUQVRIIWKHJRYHUQRUZKHQ
WKHHQJLQHLVVWDUWLQJRULGOLQJ
Condition of the governor to be on
For safety purposes, the governor is turned on when the conditions below are satisfied.
•The on/off switch conditions are set to off during power on.
•The stick switch is in the on position when it is used.
•The on/off switch is in the on position when it is used.
•Setting speed is not off.
•The engine speed exceeds to 60 % of the setting speed.
•The speed sensor is working properly.
WARNING
Safety reminder: Remember to configure your transmitter fail safe settings for
not only the throttle channel but also the governor ON/OFF channel to ensure that
the governor correctly disengages should the radio enter a fail safe condition.