77
FLT
.
E
XPERT
M
ENU
(
CYCLIC GYRO EXPERT SETTING
)
The
"
)/7(;3(57
"
PHQXV DOORZ IXUWKHU UH¿QHPHQW RI F\FOLF J\UR SHUIRUPDQFH
Refer to page 72 and display the
"
)/7(;3(57
"
screen from the
"
(;3(570(18
'
"
VFUHHQ
FLT. EXPERT screen 1/2
From 2/2 From the "RESET" of
FLT. EXPERT screen 2/2
Go to 2/2 from any cursor position
*The setting with "C#" display can be set for each condition.
1. Use the [
/+] or [ /-] key to move the cursor to "C#" and
press the [Enter] key to enter the condition selection
mode. Use the [
/+] or [ /-] key to select the condition
number "C#" and press the [Enter] key to decide the
condition number.
2. Next, adjust value of the condition selected by the [
/+]
or [
/-] key, and press the [Enter] key to enter the setting
mode. Use the [
/+] and [ /-] keys to change the setting
value. When you are done, press the [Enter] key to exit
the setting mode.
: :
:
Cond
Cond
Cond
(1) HeadHld A / HeadHld E: Head hold aileron / elevator
This features is used to adjust the heading hold aspect of the gyro control.
If the helicopter is not holding angle or cyclic control rates, increasing the
heading hold gain will improve holding the helicopter at a certain angle
and improve the cyclic rate consistency. If this is set too high you could
see an oscillation on that axis. Lowering the heading hold below default
would be used if the transmitter gain is reduced and a consistent oscilla-
tion is still not fixed during flight.
Setting ranges: 0 ~ 200% Initial value: 80%
(2) StopTune A : Stop tune aileron
Cyclic stop tuning on the aileron axis. If the helicopter continues to coast
after an after an ail roll, lowering "StpTune A" will create a harder stop ac
-
tion to remove the coasting. If the helicopter bounces on the aileron axis af-
ter an aileron control input, increasing "StpTune A" will reduce this bounce.
Setting ranges: 0 ~ 250% Initial value: 80%
To Next Page
Loading...
Need help?
General
