78
Cond
(3) StopTune E: Stop tune elevator
Cyclic stop tuning on the elevator axis. If the helicopter, after an elevator
flip, continues to coast, lowering "StopTune E" will create a harder stop
action to remove the coasting. If the helicopter continues to coast after an
elevator flip, lowering the "Stop tune E" will reduce this bounce.
Setting ranges: 0 ~ 250% Initial value: 80%
(4) HeadResp: Head Response
Head Response matches the gyro control speed to that which the heli-
copter is capable of reacting. In a standard helicopter a Head Response
of 1 should always be used, but on some scale applications, or uniquely
designed rotor heads, increasing head response might be needed to cure
over correction of the gyro.
Setting ranges: 1 ~ 10 Initial value: 1
(5) DeadBand: Dead band
Transmitter control dead band. If you are noticing inconsistent swash
plate drift or poor initialization it could be poor transmitter potentiometer
resolution. If you have to increase this value beyond 10.0, it is best to
check calibration on your transmitter.
Setting ranges: 0 ~ 25 Initial value: 4.0
Go to 1/2 from any cursor position
FLT. EXPERT screen 2/2
To Next Page
Loading...
Need help?
General
