32
8. Engine running time
Displays the running time of the engine. Up to 9,999 hours are displayed.
Use the [
/
+] or [
/
-] key to move the cursor to the operation time display and press and
hold [Enter] key to reset the display. The operation time is stored in memory even when
the power is turned off until it is reset.
Data saving screen
After setting change the following screen will be displayed
when saving data.
(Note that this is only displayed a short period of time.)
How to operate each menu screen
Use the
[
/
+] or [
/
-]
key to move the cursor to the setting item on the screen and press
the [Enter] key to enter the setting mode.
[
/
+] or [
/
-]
key to change the setting con-
tents. When you are done, press [Enter] key to exit setting mode.
How to set the function with condition (C1)
The function of each condition is set as follows.
1. Use
the [ /+] or [ /-] key
to move the cursor to "C#" and press the [Enter] key to
enter the condition selection mode. Use
the [ /+] or [ /-] key
to select the condi-
tion number "C#" and press the [Enter] key to decide the condition number.
2. Next, adjust value of the condition selected by
the [ /+] or [ /-] key
, and press the
[Enter] key to enter the setting mode. Use
the [ /+] or [ /-] key
s to change the set-
ting value. When you are done, press the [Enter] key to exit the setting mode.
*The current condition number of CGY is displayed.
*The setting with "C#" display can be set for each condition.
To Next Page
Loading...
Need help?
General
