Troubleshooting method: Check the power of the remote controller, replace the
batteries, hold the antenna of the remote controller high to the sky, move the
remote controller to the boat, and check and replace the antenna.
4. The tail hopper door cannot be opened.
Reasons: (1) The electromagnet line falls off (2) The electromagnet is damaged
(3) The main control board is damaged.
Troubleshooting method: Check the line, replace the electromagnet and main
control board.
5. The boat is out of control in the water and the lights and other functions work
normally.
Reasons: (1) The motor is wound with the fishing line or water weeds (2) The main
control board is protected due to overload.
Troubleshooting method: Stop operation, cool the motor and main control board
for several minutes, and then operate it. If the sailing function still cannot be
controlled, take back the boat and check if the propeller is clean.
6. The water enters the boat compartment.
Reasons: (1) The battery port is not covered well or the adhesive tape is damaged
and falls off (2) The water seal of the tail shaft is damaged.
Troubleshooting method: Remove the water, ventilate the boat for dryness, check
the boat and air tightness of the battery port, check air tightness of the tail shaft,
and contact with the after-sale personnel.
7. The remote control cannot control the boat, and the GPS remote control does
not display the satellite and hull power.
Reasons:(1) The power of the remote controller is low. (2) The power of the boat
is low. (3) The boat cannot bind the remote controller (Restore original factory
Settings).
Troubleshooting method: Change the batteries of the remote controller; Charge
the batteries of the boat; Contact the customer service for the bind method.
VII Upgradable configurations
To Next Page
Loading...
