1. First open the left and right battery compartment covers with the
screwdriver, take two batteries from the foam box, place them into the
left and right battery compartments of the boat, connect the battery power
lines at two ends respectively. Cover the left and right compartment
hatches.
2. Take out the boat antenna, fasten it clockwise, and fix it onto the boat
antenna seat.
3. If nesting is required on the left and right side of the middle
compartment, insert the division plate of the middle compartment into the
front and rear slot of the compartment and fix it.
4. After turning on the boat switch, the front and rear lights of the boat will
flicker three times, test the functions of the right rocker of the remote
controller. If it is normal, place the boat into the water and begin to use it.
5. Close the left and right bottom compartment plate of the middle
compartment and place the bait inside. When the middle compartment
door is remotely opened, the warning indicator will flicker.
6. To use the remote controller, place four AA-sized batteries, return all the
rockers of the remote controllers to the origin and turn on the remote
To Next Page
Loading...
