FUXTEC FX-MS152T User Manual

Original Bedienungsanleitung FUXTEC FX-MS152T_de_en_fr_rev03
41
28. Operation
STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine starts.
1. Feed fuel into the fuel tank and tighten the cap
securely.
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects as it
will start rotating upon starting of the engine.
3. Push the primer pump several times until overflown fuel
flows out in the return tube.
4. Move the choke lever to the closed position.
(1) Choke lever (2) Closed position
(3) Open position
5. Set the ignition switch to the “start” position.
1. throttle lever 2. throttle trigger
3. Stop switch
O: Stop position I: Start position
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires.
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever to the open position. And pull out the starter rope quickly to
restart engine.

FUXTEC FX-MS152T Specifications

General

Brand	FUXTEC
Model	FX-MS152T
Category	Brush Cutter
Language	English