Original Bedienungsanleitung FUXTEC FX-MS152T_de_en_fr_rev03
43
resulting in damage to the clutch system if repeated frequently.
ADJUSTING THE LINE LENGTH
• Your brush cutters is equipped with a semi- auto type nylon line head that allows the
operator to advance the line without stopping the engine. When the line becomes short,
lightly tap the head on the ground while running the engine at full throttle.
• Each time the head is bumped, the line advance about 1 inch (25.4 mm). For better
effect, tap the head on bear ground or hard soil. Avoid bumping in thick, tall grass as
the engine may stall by overload.
1. Tap knob
2. Hit knob against the ground surface lightly
3. Nylon line comes out
To Next Page
Loading...
Need help?
General
