26
CAUTION!
The engine does not come with oil in it. Therefore, ensure that you add about 0,5
liters " checking the oil level" of oil before starting it up. Use normal, multigrade
oil (SAE30). The oil level in the engine must be checked each time before mowing.
You will also need to fill in petrol, as this is also not supplied upon delivery.
WARNING Whenever you need to perform any kind of adjustment and/or
repair work on your lawn mower, wait until the blade has come to a complete
stop. Always switch off the engine before carrying out any adjustments,
maintenance or repairs.
Start the engine with the e-start
• Check the motor oil level. See “oil level check” section.
• Engage the catching bag (9).
• Depress the brake clutch pedal (3) completely and activate the locking brake (16).
• The cutter (8) must be shut off.
• Set the desired cutting height (7) • Set the gear lever (13) to neutral “N”.
• Turn the ignition key (12 ) to “start” until the motor starts, then leave it at the “on”
position.
• Throttle handle (14) controls the speed of engine.
Start the engine with the start cable.
• Check the motor oil level. See “oil level check” section.
• Engage the catch bucket (9).
• Depress the brake pedal (3) completely and activate the locking brake (16).
• The cutter (8) must be shut off.
• Set the desired cutting height (7)
• Set the gear lever (13) to neutral “N” • Turn the ignition key (12) to “ON”
• Fold the seat up and pull the start cable
To Next Page
Loading...
