31
Disengage the catch bucket (9) for emptying.
• Press the brake pedal (3) completely and activate the locking brake (16).
• Shut off the cutter (8).
• Set the gas lever (13) to neutral “N”
• Disengage the catch basket (9) and empty it.
• Engage the catch basket (9) again.
After mowing
• Always allow the motor to cool off before parking the lawnmower in an enclosed room.
• Remove grass, leaves, grease, and oil before storage. Do not store other objects on
the mower.
• Check all screws and nuts before the next use. Tighten all loose screws.
• Empty the catch basket (9) before the next use.
• Remove the ignition key
• Make sure that the mower is not parked next to a source of danger. Escaping gas
can cause explosions.
• Only original parts or parts approved by the manufacturer may be used for repairs
(see address on guaranteed certificate).
• In case of longer idle periods of the mower, empty the petrol tank with a petrol suction
pump.
• Oil and service the device
9. Maintenance and cleaning
Maintenance and repairs
Before beginning cleaning, adjustment, repair and maintenance operations, park the
machine on firm, level ground, engage the parking brake, stop the engine, allow it to
cool down and remove the ignition key.
Allow the machine to cool down before working on or around the engine, exhaust
manifold or muffler; this also applies in particular to all maintenance operations on the
mowing deck. Temperatures of 80 °C and above can be reached.
Danger of burns!
Direct contact with engine oil can be dangerous. Engine oil must not be spilled.
Cleaning: Following operation, the entire ride-on mower and the attachments must be
To Next Page
Loading...
