Note: If you are using this regulator on a disposable CO2 Cartridge, please remove any attached adapter
SETUP GUIDE
Please follow the instructions below for safe CO2 regulator setup:
1. Turn Pressure Knob counter-clockwise all the way down AND Needle Valve clockwise all the way down. This is
indicated by the “-” AND “OFF” sign respectively.
2. Ensure that the adapter (CGA-320 or Paintball) of choice is tightened down correctly. Then, attach regulator
securely to CO2 cylinder of choice.
and an sealing o ring in the regulator.
3. Ensure that the Bubble Counter is secure and tightened. Then, fill Bubble Counter chamber with water from
the top.
Note: Pressure-Proof CO2 Tubing should be attached during this time.
4. Connect the Power Plug to the regulator solenoid cable, then to a power outlet.
5. Open the flow of gas from CO2 cylinder all the way (applicable for standard CGA-320 CO2 cylinders only).
6. Turn the Pressure Knob clockwise to adjust the working pressure.
Note: Suggested working pressure is 25 PSI.
7. Adjust Needle Valve counter-clockwise to desired CO2 output.
8. CO2 bubbles should now be visible in the Bubble Counter chamber.
IMPORTANT! Double check that any and all additional CO2 accessories are attached securely before
operation. If unsure, check and repeat instructions.
To Next Page
Loading...
Need help?
General