GAC MOTOR All New GS8 - Seat Belt

14
3. Safety Operating Instructions
CAUTION
● Beforedriving,pleasecheckwhether
there are any heavy objects on the front
passenger’s seat to avoid the system
mistakenly determining that the seat is
occupied and issuing a false alarm.
● Ifthealarmremainsonaftertheseat
belt is fastened correctly, it means that
the seat belt reminder fails. In that
case, please contact the GAC Motor
authorized shop for inspection in time.
WARNING
Never insert the substitute of seat belt
tongue into the buckle to eliminate the
seat belt alarm.
: Rear seat belt indicator lamp
If rear seat belt indicator lamp is on in white,
it indicates that the seat belt is fastened, and
if the indicator lamp is on in red, it indicates
that the seat belt is not fastened or the seat
belt system is faulty. If the indicator lamp stays
red after the seat belt is fastened correctly,
it means that the SRS is failed. In that case,
please go to the GAC Motor authorized shop
for inspection in time.
The rear seat belt indicator lamp is on for 65 s
and then goes out in normal cases, and it will
light up under the following conditions:
- The rear passenger does not fasten the
seat belt when the engine starts.
- The rear passenger does not fasten the
seat belt when the rear door is opened/
closed.
- The rear passenger fastens or unfastens
the seat belt.
NOTE
This function can be activated or
deactivatedvia“Settings→DisplaySetup
→Instrument→RearSeatBeltReminder”
in the AV system.
3.2.2 Seat belt
Seat belt indicator lamp
: Driver’s seat belt indicator lamp
: Front passenger’s seat belt indicator lamp
The following alarms will be triggered when the
vehicle power switch is set to “ON” position:
- When the vehicle speed is lower than 20
km/h, if the driver or front passenger does
not fasten the seat belt, the corresponding
indicator lamp in the instrument cluster
willashforabout6sandstayon.
- If the driver or front passenger does not
fasten the seat belt at a speed higher than
or equal to 20km/h, the corresponding
indicator lamp in the instrument cluster
will flash for about 20s and stay on,
accompanied by an alarm message and a
continuous audible alarm.