GAC MOTOR All New GS8 - Page 200

194
5. Driving guide
False alarm
When there is no vehicle in the blind spot, the
system may issue a false alarm in case of the
following conditions:
- The vehicle is near a road guardrail.
- The vehicle is near a highway concrete
wall.
- The vehicle is in a building area.
- The vehicle is passing a sharp turn
around a building.
- The vehicle is near shrubs and trees.
CAUTION
The false alarm, if triggered, just lasts
for a short time and can be corrected
automatically.
Radar sensor
The BSD radar sensors are installed as shown
above.
CAUTION
Make sure that the area around the rear
bumper sensors is not covered by ice,
snow or other objects.
If any sensor is interfered, the system
performance will be degraded and the
instrument cluster will display a prompt “BSD
sensor is blocked” and issue an alarm. The
system will automatically return to normal if
any of the following conditions is met:
- A vehicle is detected on both sides of the
vehicle.
- Thevehicleispoweredo󰀨andtheengine
is restarted.
If the sensor is still interfered when the engine
has been restarted, the reminder will be
given again and an alarm will be issued. If
the message reading “Please check the side
assist system” is displayed on the instrument
cluster, it indicates that the system is faulty,
please go to the GAC Motor authorized shop
for inspection in time.