221
5. Driving guide
WARNING
● Whenahigh-pressurecleaneris
used, clean the radars in snatches
gently, with the nozzle at least 30cm
away from the sensor.
● Ifwaterdropsareonthesurfaceof
the RPA sensor on the bumper, the
sensitivity of the sensor will reduce.
Wiping off them can restore the
sensitivity of the radar.
● Thesurfaceofsomematerialscannot
reflect the signal from the RPA
sensors, so that the RPA sensors
cannot detect such materials or
people wearing the clothing made of
such materials.
● Noise sourcesoutsidethevehicle
may interfere with the RPA sensors,
preventing them from detecting any
object.
● TheRPAsensorisaprecision
component, which shall not be
removed,rettedandrepairedwithout
authorization. Otherwise, GAC will
not assume any responsibility for the
damage arising therefrom.
5.5.2 Reverse image system *
The reverse image system can provide video
recorded at wide angle up to 130° and display
a wide-range image behind the vehicle on the
AV system display to allow the driver to know
various complex road conditions behind the
vehicle and improve the safety of reversing.
Activating and deactivating reverse image
system
With ignition switch set in “ON”, the reverse
image system will automatically start working if
the gearshift lever is moved to the “R” position.
In this case, the AV system display will begin to
show the image behind the vehicle and display
the dynamic trajectory in the reverse image.
If the gearshift lever is move out of the “R”
position, the reverse image system will
automatically stop working and the AV system
display will exit from the reverse image.
WARNING
The reverse image system cannot take
the place of the driver’s observation to
the surrounding environment. The driver
shall be concentrated and reverse safely
according to the actual conditions.
Dynamic trajectory
The display screen shows the track of the
wheels and the driving route of the vehicle
body:
①
RPA sensor display area
②
Reversing image display area
To Next Page
Loading...
