GAC MOTOR All New GS8 - Around View Monitor (AVM)

224
5. Driving guide
NOTE
● WhentheAVMisactivated,theAV
system display will show the image
around the vehicle and the reversing
guidelines.
● Iftheforwardspeedisgreaterthan
20km/h, the system will be automatically
deactivated.
● Whenthegearshiftleverisnotinthe
“R” position and the AVM has been
activated for more than 30s, the AVM
will be automatically deactivated (at zero
vehicle speed).
● IftheAVsystemisnotcompletely
activated, the AVM cannot function
properly.
5.5.3 Around view monitor
(AVM)*
The AVM collects the left, right, front, rear
images of the vehicle and integrate them into
a 360° bird’s-eye view of the surrounding
environment, which is displayed on the AV
system display to provide the driver with
information on the surrounding environment
of the vehicle and to reduce blind spots
during driving. In addition, it can take the
parameters such as steering wheel angle
and vehicle dimensions into consideration
to predict the vehicle’s motion trajectory as
well as superimpose the predicted track on
the panoramic image to provide the driver
with full information on the vehicle’s direction
of traveling, helping the driver to determine
whether reversing is safe.
OnandO󰀨
1. With vehicle power switch in the “ON”
position, the AVM can be activated/
deactivated via the gearshift lever:
- When the gearshift lever is moved to the
“R” position, the AVM will be activated
automatically.
- When the gearshift lever is moved out of
the “R” position and the driver do not carry
out any relevant operation, the AVM will
be deactivated automatically after 30s.
2. With vehicle power switch in the “ON”
position, the AVM can be activated/
deactivated by pressing the button :
- When the button
is pressed, the button
indicator lamp will come on and the AVM
will be activated.
- When the button
is pressed again, the
button indicator lamp will go out and the
AVM will be deactivated.
3. With vehicle power switch in the “ON”
position, the AVM function can be
activated by touching the icon
in the AV
system menu bar to enter the AV system
interface and then touching the “AVM”
icon.