GAC MOTOR All New GS8 - Brake Fluid

261
6. In-service maintenance
Replacing rear windshield wiper blades
- Hold the wiper arm
①
by hand, and push
the wiper blade
②
as arrowed to remove it.
- Slowly lower the wiper arm.
- Install the new wiper blade into the wiper
arm in reverse steps. It is installed in
place when a “click” is heard.
- Gently put the wiper arm back on the
windshield.
If replacing wiper blades is required, it is
recommended to go to the GAC Motor
authorized shop for replacement.
CAUTION
● Whenliftingthewiperarm,pleasegrasp
the wiper arm with hands, rather than
grasp the soft wiper blade.
● Newwiperbladeswiththesamelength
andspecicationsasthepreviousones
must be used.
● Becarefulwhileloweringthewiperarm
to prevent it from falling and hitting the
windshield instantly.
● Thestatusofthewiperbladesmust
be checked regularly, and the wiper
blades must be replaced as specified.
Damaged wiper blades must be
replaced in time.
● Excessivelywornordirtywiperblades
are very easy to scratch the windshield
and will affect the field of vision when
used, reducing driving safety.
6.4.5 Brakeuid
Functionofbrakeuid
Brake fluid is used to transmit power in the
hydraulic brake system of the vehicle.
The brake fluid is water-absorbent, so it
can continuously absorb moisture in the
surrounding air during use. If the brake fluid
stays in the system for too long and absorbs
too much moisture, air resistance will generate
in the system pipeline during braking, reducing
thebrakinge󰀨ectandimpairingdrivingsafety;
it may even cause the complete failure of
the brake system, resulting in accidents.
Therefore, be sure to go to the GAC Motor
authorizedshoptocheckthebrakeuidlevel
or change the brake fluid according to the
periodspeciedintheWarranty Manual.
NOTE
Specicationsofbrakeuid:DOT4.