85
4. Operation of systems and equipment
4.3.3 Wiper combination switch
When the ignition is in the “ON” position, the
wiper combination switch can be operated as
follows:
①
MIST: continuous wiping
②
OFF:frontwindshieldwipero
③
AUTO: automatic wiping
④
LO: wiping at low speed
⑤
HI: wiping at high speed
⑥
front windshield washer system on
⑦
automatic wipe sensitivity adjustment
knob
⑧
: rear windshield washer system on
⑨
OFF:rearwindshieldwasherorwipero
⑩
ON: rear wiper on
MIST: continuous wiping
- If the wiper combination switch is turned
to the MIST position
①
, the front wiper
will start wiping continuously.
- If the wiper combination switch is released
to automatically return to the OFF position
②
, the front wiper will stop wiping.
OFF:wipero
- If the wiper combination switch is turned
to the OFF position
②
, the front wiper will
stop wiping.
AUTO: automatic wiping
- If the wiper combination switch is turned
to the AUTO position
③
, the automatic
wiping function will be activated, and the
wiper system will adjust the wiper speed
according to the current rainfall and the
real-time vehicle speed.
- Adjust the wiping sensitivity by turning the
knob /
⑦
up/down.
- This function can be activated or
deactivatedbyselecting“Settings→Body
Accessories→OtherAccessories→Auto
Wiping” on the A/V system display.
CAUTION
● Iftheinstrumentclusterdisplays“Sensor
Failure, Please Manually Control Wiper”,
for the sake of safety, you should
manually control the wiper and go to
the GAC Motor authorized shop for
inspection in time.
● Beforeactivatingtheautomaticwiping
function in winter, please check whether
the wiper blade is frozen.
● Itisrecommendedtodeactivatethe
automatic wiping function when washing
the vehicle, in dusty weather and in
rainless weather to avoid unintentional
action of the wipers which may cause
damage or personal injury.
● Theautomaticwipingfunctionisan
assist, so the driver should manually
operate the wipers when necessary
according to the driving situation to
ensure driving safety.