115
4. Operation of systems and equipment
CAUTION
setting state: If any seat motor is not
position and enable”, the system will
ignore this memory request signal,
exit the setting state of nap mode, and
perform the recovery action of nap
mode.
If any seat motor is not in a static state
ignore this memory request signal and
maintain the nap mode.
Nap mode*
When the vehicle power switch is set to the ON
position and the transmission is in P gear, the
driver can set and save the nap mode position
then have a rest and relax.
time, it is necessary to set and save the
nap mode position. After adjusting the
Enable” to keep the nap mode at the
current position.
- When the nap mode has a memorized
position and you enter the nap mode
again, you can click “Enable” to enter
the nap mode, and click “Cancel” to exit
the nap mode and return to the previous
position.
- After entering the nap mode, if the seat
position is adjusted, the box will be
popped up to prompt “save” the new
- When the nap mode has a memory
position, if the user switches out of P gear,
the nap mode will be exited and the seat
will not move; When the vehicle power
user can exits the nap mode by vioce,
or click the “Exit” through the central
controller to exit nap mode. After the
system exits the nap mode, the seat
returns to the previous position.
4.4.3 Rear seat
Folding down of rear seat backs
- Folding down: Press the rear seat back
switch as arrowed to fold down the rear
seat back.
- Restore: Push the rear seat back directly
backward until the seat back is locked.
To Next Page
Loading...
