EasyManua.ls Logo

GAC MOTOR EMPOW - Start The Engine

GAC MOTOR EMPOW
356 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
175
5. Driving guide
Limphomemode
If the smart key battery is low and the
instrument cluster display prompts “No key
detected”, you can try to place the smart key
horizontally at the key mark at the bottom of

  

button the backlight color turns green, and
  
engine.
This method is intended for emergency start.
Please replace the battery of the intelligent
remote control key as soon as possible.
5.1.2 Start the engine
- Enter the vehicle with the intelligent
remote control key.
- Make sure the gear is in “P” or “N”.
 

is green
  
to start the engine.
NOTE
In case of a cold start, run the engine at
idle speed to warm up it before driving. At
the same time, the valve tappet takes a
few seconds to reach the normal working
pressure and operation noise will occur,
which is normal.
CAUTION
 
15s. If the engine is not started
successfully, you must wait about 30s
before next attempt.

hard to make the engine run at high
speed or overload after starting.
Otherwise, the engine is likely to be
damaged.
     
cannot be started, try to start it by a
jumper cable. 335

pushing or towing the vehicle.

Table of Contents

Related product manuals