GAC MOTOR EMPOW - Emergency Start

335
8. Accident handling
8.8 Emergency start
Jumpercable
If the engine cannot start because the battery
is too low, it can be started by connecting
this battery to the battery of another vehicle a
jumper cable.
WARNING
● Enginecompartmentisahighlyrisky
area, and improper operation can
easily lead to casualties.
● Besuretocarefullyreadandobserve
the safety warning instructions
related to battery operation before
starting operation on the battery.
CAUTION
Before the jumper cable operation, be
sure to turn off all electrical consumers of
the vehicle with power shortage, such as

While connecting the batteries of two vehicles,
be sure to first connect the positive terminal
and then the negative terminal.
  
position.
- Connect end
①
of the red cable to the

battery “A”, and end
②
to the positive

- Connect end
③
of the black cable to
  
“B”, and connect end
④
to the engine
  
the engine block of the vehicle with the
depleted battery “A”.
CAUTION
Properly place the jumper cable to avoid
contact between the cable and the moving
parts of the engine.
 
battery and let it idle. Then, start the
engine of the vehicle with the depleted
battery till the engine runs smoothly.