GAC MOTOR GS4 - Page 140

134
5. Driving guide
Limphomemode*
When “No key detected” appears on the
instrument cluster display due to low battery
of the intelligent remote control key, you can
try to place the key horizontally at the mark on
the bottom of the front cup holder, then press

it to “ACC” or “ON” position and depress the
 
STOP button indicator lamp turns green, press
 
engine.
This method is intended for emergency start.
Please replace the battery of the intelligent
remote control key as soon as possible.
Conventional ignition switch*
The ignition switch has 4 positions:
- LOCK (OFF): circuits are not connected
and the key can be removed only in this
position.
- ACC: circuits of accessories such as the
vehicle inlet are connected.
- ON: the instrument cluster backlight
comes on, and the circuits of all electrical
consumers are connected; after the
engine is started, the ignition switch will
be switched to this position.
- START: this position is only used to start
the engine.
NOTE
In case of failure to turn the key from “LOCK”
position to “ACC” position, the steering
wheel may be turned slightly to disengage
the steering wheel locking mechanism until
the key can be turned to switch the position
of the ignition switch.