135
5. Driving guide
Vehicle model with a conventional ignition
switch:
- Insert the mechanical key into the ignition
switch.
- Make sure the gearshift lever is in the “P”
or “N” position.
- Depress the brake pedal and ensure
indicator lamp turns green.
- Turn the mechanical key to switch the
ignition switch to “START” position to start
the engine.
Vehicle models with an ENGINE START/
STOP button:
- Enter the vehicle with the intelligent
remote control key carried.
- Make sure the gearshift lever is in “P” or
“N” position.
- Depress the brake pedal and ensure
indicator lamp turns green.
to start the engine.
5.1.2 Engine start
NOTE
idle speed to warm up it before driving.
At the same time, the valve tappet takes
a few seconds to reach the normal
working pressure and operation noise
will occur, which is normal.
STOP button: if the engine cannot
be started normally due to the brake
signal failure, try to switch the ENGINE
Ensure that the gearshift lever is in the
“P” or “N” position, and press and hold
s to force the engine to start.
CAUTION
The engine start time shall not exceed
15s. If the engine is not started
successfully, you must wait about 30s
before next attempt.
Do not depress the accelerator pedal
hard to make the engine run at high
speed or overload after starting.
Otherwise, the engine is likely to be
damaged.
If the battery level is low and the engine
cannot be started, try to start it with a
jumper cable.
It is prohibited to start the engine by
pushing or towing the vehicle.
To Next Page
Loading...
