146
5. Driving guide
NOTE
If the brake pedal is not depressed and
the EPB button is pressed, the EPB will
not be released, the buzzer will sound
an alarm and the instrument cluster
display will prompt “Please depress the
brake pedal to release the EPB”.
When the EPB is being released,
operation noise will occur, which is
normal.
When the vehicle battery is low, the
system cannot release the EPB. If
possible, connect a jumper cable for
emergency start => See page 262 to
release the EPB. In this case, contact
the GAC Motor authorized shop for
inspection.
If the EPB has not been used for a long
time, the system will automatically test
it, and operation noise will occur.
Apply the dynamic emergency brake
- If the service brake fails during driving,
pull up the EPB button
①
constantly to
achieve emergency braking, and then
release the EPB button or depress the
accelerator pedal so the system exits
emergency braking.
CAUTION
In the following cases, operate the EPB
again. If the fault is not eliminated, please
contact the GAC Motor authorized shop for
inspection.
flashes in red
continuously, it indicates that the EPB
system is malfunctioning.
comes on in red
when EPB is not applied, it indicates
that the system is abnormal.
comes on in
yellow, it indicates that a fault is detected
in EPB and the EPB is degraded.
To Next Page
Loading...
