GAC MOTOR GS4 - Page 153

147
5. Driving guide
CAUTION
  
when it is not necessary. It is easy
to cause traffic accidents, increases
the braking distance in comparison to
depressing the brake pedal to brake,
and shorten the service life of the park
brake system.
 
vehicle is running, the instrument cluster
will give an alarm message together
with an audible beep alarm.
  
accelerator pedal during application of
dynamic emergency brake, the EPB will
be released.If the EPB button is pulled
up until the vehicle stops, the EPB will
remain engaged.
AUTOHOLD*
AUTO HOLD can keep the vehicle still
automatically based on the driver’s braking
intention; when the system detects the driver’s
startup intention (for example, when the
accelerator pedal is depressed), AUTO HOLD
will automatically release the brake; AUTO
HOLD can ensure the ease of startup when
the brake is released automatically according
to the slope information; AUTO HOLD can
actively increase the pressure when the
󰀩
vehicle still.
OnandO󰀨
- When the driver’s door has been closed,
the engine is started and the driver’s seat
belt is fastened, press the AUTO HOLD
button
②
. Then, the button indicator
lamp comes on, and the AUTO HOLD is
enabled.Press this button again. The button
indicator lamp goes out, and the AUTO
HOLD is disabled.
Activation
When this function is enabled, it supports
automatic brake holding and releasing under
stop & go conditions. When the driver brakes
the vehicle, the vehicle will be automatically
parked to avoid slide at startup.
Exit
Under the following conditions, AUTO HOLD
will be disabled and the parking brake will not
be locked:
1. The accelerator pedal is depressed at
startup.
2. The engine stops while the vehicle is
running.
3. The EPB is manually released.
4. When the brake pedal is depressed, the
AUTO HOLD button is pressed.