149
5. Driving guide
NOTE
automatically.
activated by pressing the button .
is pressed and held for
more than 10 s, the system will identify
it as a wrong operation, and the working
ESP indicator lamp
- After the ignition switch is switched to “ON”
position, the indicator lamps
and will
be on for a few seconds and go out after
the system completes self-test.
- If ESP works during driving, the indicator
lamp
- After ESP is deactivated, the indicator
lamp
will light up.
- When ESP is faulty, the indicator lamp
will light up.
After the engine is started, if the indicator lamp
lights up, it indicates that ESP has been
deactivated, and the instrument cluster display
shows an alarm message. You can try to turn
the system again. When the indicator lamp
goes out, it indicates that the system has fully
entered the working state.
If the battery connector is disconnected from
and then connected to the cable, the indicator
lamp
may come on when the ignition switch
is turned on, and then goes out after a short
driving distance.
For driving safety, it is recommended to enable
ESP.The ESP can be disabled in the following
special cases:
- when the vehicle travels with tire chains.
- when the vehicle travels on roads covered
with deep snow or on soft grounds.
- when the vehicle is trapped on muddy
roads, etc., and you need to move it back
and forth.
Traction Control System (TCS)
TCS is a subsystem of ESP.As the subsystem
of ESP, TCS determines if the driving wheel
slips based on the speed of the driving wheel
and the drive wheel, and if the speed of driving
wheel is higher than that of drive wheel, it will
limit the speed of the driving wheel to prevent
vehicle slip.
When ESP is turned off or on, TCS will be
To Next Page
Loading...
