EasyManua.ls Logo

GAC MOTOR GS4 - Driver Assistance Systems; Cruise Control

Default Icon
273 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
152
5. Driving guide
- Press the button again to deactivate the
HDC, and then the indicator lamp
goes out.
After the HDC is activated, if the driver does
not depress the brake pedal while going
downhill, the vehicle keeps running at the

The driver can adjust the vehicle speed by
depressing the accelerator pedal or the brake
pedal:
 
the pedal is released, HDC is activated
again to keep the vehicle going downhill
at the current speed.
- When the vehicle speed is higher than 60

- When the HDC is active, ESP
automatically intervenes in driving if the
wheels slip excessively.
NOTE
   
is deactivated and a graphic prompt
message is displayed on the instrument
cluster display with an audible alarm
lasting for about 5 s.In this case, HDC
cannot work properly, and the driver
should depress the brake pedal to
decelerate instead of trying to use the
system to go down a steep slope. In
addition, the driver should go to the GAC
Motor authorized shop for inspection as
soon as possible.
  
enters the thermal protection mode due
to too high braking temperature. For
example, when the system operates at a
high ambient temperature for a long time,
the temperature of the brake system
constantly increases due to friction.
When the upper limit of temperature
has been reached, the HDC enters the
thermal protection mode (i.e., the HDC
function is active but inoperative) and is
temporarily deactivated, and the vehicle
shows signs of acceleration. When the
temperature of the brake system drops
to the level where the brake system can
work effectively, HDC resumes normal
operation.
5.4 Driver assistance systems
5.4.1 Cruise control*
The cruise control allows the vehicle to run
without depressing the accelerator pedal at the

WARNING
● Whendrivingonhigh-trafficroads,
slopes, multi-curve roads or slippery
roads, do not use the cruise control
to avoid accidents.
● Thecruisecontrolshallbeusedwith
caution. After setting the vehicle
speed, ensure that the vehicle can
maintain a safe distance from the
vehicle in front.
Thecruisecontrolshould be
switchedo󰀨intimeafteruse.
● Thecruisecontrolisonlyusedfor
assistant driving and cannot replace
automatic driving, so the driver must
be vigilant to drive and control the
vehicle.

Table of Contents

Related product manuals