GAC MOTOR GS4 - Intelligent High Beam

183
5. Driving guide
WARNING
Intelligent high beam is a driving
assistance, which can help you in using
the lamp in the best way under suitable
conditions. The driver shall always be
responsible for manually switching
between the high and low beams when
thetra󰀩candenvironmentalconditions
require.
● Theintelligenthighbeammaynotbe
able to correctly identify all driving
environments and cannot operate
properly in some environments.
● Iftheintelligentforwardcamerais
blocked by dirt, stickers, ice and
snow, etc., the intelligent high beam
may be inoperative.
● Ifthevehicle’slightingsystemis
modied(forexample,theheadlights
are modified), the performance of
the intelligent high beam may be
degraded or its function may be
inoperative.
● Whenthisvehicleisabouttomeeta
non-motor vehicle (such as, a bicycle
or an electric bicycle) or a pedestrian,
the intelligent high beam system
shall be de-activated in time to avoid
dazzling the driver of the non-motor
vehicle or the pedestrian.
5.4.8 Intelligent high beam *
The intelligent high beam system detects the
traffic and environmental conditions in real
time via an intelligent forward camera sensor
and it can automatically switch between the
low beam and high beam. For example, the
vehicle driver activates the intelligent high
beam in case of driving on a road with poor
lighting at night. When the system detects
that the operating conditions of high beam are
met, the high beam is automatically switched
on; when the system recognizes that another
vehicle traveling in the opposite direction or a
following vehicle is approaching to this vehicle,
it automatically switches from high beam to low
beam.
NOTE
In the case of heavy fog, rain, etc., which
may dazzle the driver, the low beam is
required to be activated.
Activating intelligent high beam*
Follow me home
Quickly turn the lamp switch and turn it back within 10 minutes after shutdown to activate this
function
OFF Low beam
Low beam + rear
fog lamp
Daytime running lamp
It lights up automatically once the vehicle is started
Intelligent high beam
It switches between high and low beams depending on the speed,
traffic environment and other conditions
The vehicle detects the intelligent remote control key and automatically
switches on the courtesy lamp
Intelligent courtesy lamp
Light Control
Driving
Assistance
Intelligent Body
A/C Settings
1. When the ignition switch is set to “ON”
 

and press the soft key
to set the IHC
to “ON”.
NOTE
The setting has a memory function that
keep itself at the same state with the one
before last shutdown when the vehicle has
started.