GAC MOTOR GS4 - Reverse Image System

194
5. Driving guide
WARNING
● Duringcleaningaradarsensorwitha
high-pressure cleaner, clean it gently
in snatches and the nozzle shall be at
least 30cm away from the sensor.
● Ifwaterdropsareattached tothe
surface of the RPA sensor on the rear
bumper, the sensitivity of the sensor
will reduce. Wiping off them can
restore the sensitivity of the radar.
● The surfaceofsomematerials
cannot reflect the signal from the
RPA sensor, so that the RPA sensor
cannot detect such materials or
people wearing the clothing made of
such materials.
● Noisesourcesoutsidethevehicle
may interfere with the RPA sensor,
preventing it from detecting any
target.
● The RPAsensorisaprecision
component, which shall not be
removed,rettedandrepairedwithout
authorization. The company does
not assume any responsibility for
the damage caused by unauthorized
removal&rettingandrepair.
5.5.2 Reverse image system *
 
angle up to 130° and display a wide-range
image behind the vehicle on the AV system
display so as to help the driver to observe
complex road conditions behind the vehicle
and improve the safety of reversing.
OnandO󰀨
In case of the ignition switch set to the
“ON” position, the reverse image system
automatically starts to operate if the gearshift
lever is moved to the “R” position. In this case,
the AV system display begins to show the
image behind the vehicle and displays the
reversing guideline in the reverse image.
If the gearshift lever is move out of the
“R” position, the reverse image system
automatically stops operating and the AV
system exits from the reverse image.
WARNING
Reverse image system cannot take the
place of the driver’s observation of the
surrounding environment. The driver
shall focus on safely reversing and
positionadjustmentaccordingtothe
practical conditions.
Dynamictrajectory
The reversing guidelines shown on the display
may change direction with the steering wheel
turned so as to indicate the driving route of the
󰀨
NOTE
All above-mentioned reversing guidelines
are reference vehicle trajectories obtained
by testing on a flat ground. In case of
driving on a slope, the above trajectories
cannot be used as accurate reference.